Using T Post With Chain Link Fence

The fabric is stretched between terminal posts.

Using t post with chain link fence.

Chain link fencing is a very different type of fencing. Holes for terminal posts end gate and corner posts should typically be a little bit wider and deeper than line posts the posts in between terminal posts. For holes next to the house use a shovel post hole digger and digging bar. In general for residential chain link fences dig holes 6 in diameter by 30 deep or below frost line in your area.

Attach the clip securely to the chain link and repeat the process at the bottom of the fence. Our chain link fence post fittings category includes all the common chain link fence parts that are used to attach the chain link fabric framework and or barb tension wire to the fence posts. X our yardgard 2 19 50 in. Slide the clip through the chain link and around the top of the t post.

Dig the holes to size. We offer everything from common fence parts like tension bars tension bands brace bands post caps to specialty chain link fence parts like post anchors barb wire arms post extensions clamps and. A 2 diameter post would require a 6 diameter hole and put one third of. Our yardgard 2 19 50 in.

In open areas consider using a power auger to save time and effort. Attach the end of the chain link to the wire with a t post clip. 16 gauge silver galvanized steel chain link fence line post. Step 1 depending on the geographical location fence height and fencing materials used post hole size may vary.

The bar makes the end of the fence rigid and provides something to attach to the posts. T post is only designed to support light duty welded wire fencing. Galvanized steel is the strongest mesh. Chain link fabric or mesh is usually sold in rolls 4 5 or 6 feet high.

Lay the chain link mesh on the ground outside the fence. Item 552276 model 58910123. These posts can be used at the end of a line of fence at a fence corner or for gate posts. Unroll the chain link fence and place the end of the roll at any corner t post.

Run a tension bar through the links at the end of the mesh.